Jump to content
  • 0
IGNORED

3D printer required to print a mod for JJPGnR


Budgie
 Share

Question

Hi Guy's,

I need help to print a rubber post mod for where the ball lodges and sticks beside the post and right bottom pop bumper on my JJP Guns n Roses.

I don't own or have access to a 3D printer so am hoping someone on here might have one and be able to print me the part please.

I have attached the file below which I got from the JJP owners club on pinside.

Any help would be greatly appreciated.

 

Ball+Saver+on+the+Bumper+from+Guns+and+Roses+JJP+Pinball.zip

Link to comment
Share on other sites

6 answers to this question

Recommended Posts

  • 0

How strong does this need to be? I can resin print it but only have a standard resin at the moment which can be rather brittle. You can get "abs-like" resin so if someone has that - otherwise it should probably be FDM printed with PLA or PET or HIPS (ordered in difficulty to print).

 

A solid resin print of this would use around 1.5ml of resin, (1.6 g) and cost less than 50 cents in raw resin. Add in print time and other costs and it would still be around $4 if done in multiples. FDM printing of these would cost very similar in materials, but the print time goes through the roof for printing multiples...

Link to comment
Share on other sites

  • 0
On 23/08/2021 at 12:25 AM, Budgie said:

Hi Guy's,

I need help to print a rubber post mod for where the ball lodges and sticks beside the post and right bottom pop bumper on my JJP Guns n Roses.

I don't own or have access to a 3D printer so am hoping someone on here might have one and be able to print me the part please.

I have attached the file below which I got from the JJP owners club on pinside.

Any help would be greatly appreciated.

 

Ball+Saver+on+the+Bumper+from+Guns+and+Roses+JJP+Pinball.zip 72.7 kB · 29 downloads

I know this post is a little old now but was curious if you sorted your printing of the mod.

I have a PRUSA i3 MK3 and good experience in 3D printing if you need help (pay postage and I will print it for free).

Always happy to help other pinball enthusiasts 🙂

  • Like 1
Link to comment
Share on other sites

  • 0
On 08/05/2022 at 1:36 AM, Strahany said:

I know this post is a little old now but was curious if you sorted your printing of the mod.

I have a PRUSA i3 MK3 and good experience in 3D printing if you need help (pay postage and I will print it for free).

Always happy to help other pinball enthusiasts 🙂

All sorted, thanks for the offer.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...