Jump to content
Due to a large amount of spamers, accounts will now have to be approved by the Admins so please be patient. ×
  • 0
IGNORED

WOZ Fault


gardog62

Question

7 answers to this question

Recommended Posts

  • 0
Both says cannot find required map name .

when trying to find obvious fault causing this ( no luck there ) discovered cables tucked up in loom and that Capture Dorothy led board missing

 

Hmmm.... WOZ can be frustrating when a board goes, but it will be even worse if you are completely missing one. These can be bypassed, and connect the cables to the next board in line, go into settings and disable the one you are missing. However you would be better of ordering a new one and not bypassing it.

 

Then hopefully all will be back to normal. (Only If no other boards are gone also)

Link to comment
Share on other sites

  • 0

Thanks Wayne reseating sata cable to ssd did the trick machine now fires up .

 

# 1 Completely missing the capture Dorothy lamp board # 15-0006-00 plug a tail just floating will have to check wiring loops also .

# 2 Upper part of playfield lit not lower half # 8 down on yellow brick road .another issue to sort .

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...