gardog62 Posted January 12, 2019 Share Posted January 12, 2019 Any WOZ owners had this fault ? Cannot find required map name . Wont boot up Link to comment Share on other sites More sharing options...
0 RPZ Posted January 12, 2019 Share Posted January 12, 2019 So the fault is that it doesn’t boot? Thought you had a lights problem... Link to comment Share on other sites More sharing options...
0 gardog62 Posted January 12, 2019 Author Share Posted January 12, 2019 Both says cannot find required map name . when trying to find obvious fault causing this ( no luck there ) discovered cables tucked up in loom and that Capture Dorothy led board missing Link to comment Share on other sites More sharing options...
0 RPZ Posted January 12, 2019 Share Posted January 12, 2019 Both says cannot find required map name . when trying to find obvious fault causing this ( no luck there ) discovered cables tucked up in loom and that Capture Dorothy led board missing Hmmm.... WOZ can be frustrating when a board goes, but it will be even worse if you are completely missing one. These can be bypassed, and connect the cables to the next board in line, go into settings and disable the one you are missing. However you would be better of ordering a new one and not bypassing it. Then hopefully all will be back to normal. (Only If no other boards are gone also) Link to comment Share on other sites More sharing options...
0 Ballypinball Posted January 12, 2019 Share Posted January 12, 2019 Any WOZ owners had this fault ? Cannot find required map name . Wont boot up remove a refit sata cables to the SSD drive Link to comment Share on other sites More sharing options...
0 gardog62 Posted January 12, 2019 Author Share Posted January 12, 2019 You are talking to a techtard .I am guessing some sort of hard drive and assoc cables . I am assuming this must be dont when off turned off ? Link to comment Share on other sites More sharing options...
0 Ballypinball Posted January 12, 2019 Share Posted January 12, 2019 yes turn off Link to comment Share on other sites More sharing options...
0 gardog62 Posted January 12, 2019 Author Share Posted January 12, 2019 Thanks Wayne reseating sata cable to ssd did the trick machine now fires up . # 1 Completely missing the capture Dorothy lamp board # 15-0006-00 plug a tail just floating will have to check wiring loops also . # 2 Upper part of playfield lit not lower half # 8 down on yellow brick road .another issue to sort . Link to comment Share on other sites More sharing options...
Question
gardog62
Any WOZ owners had this fault ?
Cannot find required map name .
Wont boot up
Link to comment
Share on other sites
7 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now