Due to a large amount of spamers, accounts will now have to be approved by the Admins so please be patient.
×
- 0
IGNORED
IJ driver board schematics
-
Recently Browsing 0 members
- No registered users viewing this page.
Question
raysco
I have just changed headers on j115 on an IJ driver board, however the documentation in the manual doesn't make sense. I don't have the actual board schematics but looking at what I have replaced then pin 1 is going to ground ( board edge) and pin 12 was also going to the board edge which I assume is ground however the manual shows this as being a GI a.c. Voltage.
There are no direct jumpers across the pins however some were soldered together.
Can someone send me a picture of the actual board schematics for j 115 on an Indiana Jones driver board, or explain what I am seeing :blink:
Edit : It was late, I should have said "Please can"
Edited by rayscoLink to comment
Share on other sites
4 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now