Due to a large amount of spamers, accounts will now have to be approved by the Admins so please be patient.
×
- 0
IGNORED
Nanao MS9 Monitor Issues
-
Recently Browsing 0 members
- No registered users viewing this page.
Question
mng70
Hi everyone. I was hoping I could get some advice on an issue I'm experiencing on recently installed Nanao MS9 monitor / chassis in my Egret II. I appear to have some geometry issues. I have been playing around with the chassis pots (using Emphatic's useful guide) and the pots on the remote board but I always appear to have a wave as seen on the screenshots below.
I hope I've managed to share the images below correctly. Please inform me if you cannot view them.
https://photos.app.goo.gl/QVyk9XK7RjDWJPDq5
https://photos.app.goo.gl/A6MFxM6bWSYd4bWu5
Ignore the green vertical line.
https://photos.app.goo.gl/A6MFxM6bWSYd4bWu5
https://photos.app.goo.gl/pShdRaRd1wCQrPC4A
I do have access to another shared chassis (the same Nanao chassis as the one that is currently connected except it has the manual 15KHz / 24KHz adjustment). Could it be a chassis issue and is it worth swapping out or do you think it is a tube issue?
Although I am quite new to monitor diagnosis any help would be gratefully received.
Many thanks
mng70
- - - Updated - - -
A couple of videos of the display can be viewed here
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now