Thanks Thanks:  0
Likes Likes:  0
Results 1 to 3 of 3

Thread: Solid State Relay Question

  1. #1

    Join Date
    Oct 2005
    State
    Brisvegas
    Posts
    2,610
    Mentioned
    18 Post(s)
    Quoted
    64 Post(s)

    Solid State Relay Question

    I haven't played with SSR's at all so I'm after some advice. I have a machine that runs a D2W110DD Solid State Relay which I believe is kaput. I'm trying to fiugre out what I could replace it with as I cannot seem to locate the original part. Data sheet below.

    https://www.digchip.com/datasheets/p...W110DD-pdf.php

  2. #2

    Join Date
    Jun 2013
    State
    NSW
    Posts
    300
    Mentioned
    7 Post(s)
    Quoted
    97 Post(s)
    Australia

  3. #3

    Join Date
    Aug 2018
    State
    Victoria
    Posts
    6
    Mentioned
    0 Post(s)
    Quoted
    1 Post(s)
    Australia

    SSR replacement

    Solid sate relays perform the same function as normal relays except that they switch when the AC voltage crosses thru zero so there is usually minimal inrush current on transformers, they also do not produce the usual back EMF spike from the coil as there is none, so no need for quenching diodes, that said I find Fleabay the best place to shop, I have even purchased some DC versions in the past, the relays all share a common foot print, so the fixings are all the same, your one has quick connect terminals, most have screw terminals.
    So long as the rated working voltage meets or exceeds the supply voltage and the current is not greater than the relay is rated for then you are all good. If the one you have is Cactus you would do well to find out what caused its demise before whacking in the next victim, regards Michael.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. WPC Alpha: DMD or Solid State era?
    By ajfclark in forum Pinball Polling Booth
    Replies: 14
    Last Post: 1st August 2018, 08:33 AM
  2. Solid state jumpers
    By Railways in forum Pinball Technical and Repair Questions
    Replies: 3
    Last Post: 22nd May 2013, 02:02 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •