Tombstone Posted September 26, 2018 Share Posted September 26, 2018 This seems to be the problem can't get the arm to release, I've disconnected the drive motor and the tone arm gear. The assembly looks like its in the wrong place. Any help for this newbie?[ATTACH=CONFIG]136308[/ATTACH] Link to comment Share on other sites More sharing options...
0 Tombstone Posted September 27, 2018 Author Share Posted September 27, 2018 OK got the gripper arm freed up but got something out of sync. Link to comment Share on other sites More sharing options...
0 starskuch Posted December 4, 2018 Share Posted December 4, 2018 Hi, It’s late but not too late and I send a reply. Disconnected current, gently by hand, turn the gripper shaft gear (on left) until the gripper arm back in his home position (grip arm over record magazine). Put the gripper motor gear against the gripper shaft gear and tighten the 3 screw of the grip motor. Gently by hand, rotate the knurled end of the grip motor: the gripper arm must move and come to turntable. Rotate the grip motor to move gripper arm back in his home position. If everything works, put the current, make a selection. Best regards Link to comment Share on other sites More sharing options...
Question
Tombstone
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now