Jump to content
Due to a large amount of spamers, accounts will now have to be approved by the Admins so please be patient. ×
  • 0
IGNORED

Nanao MS9 Monitor Issues


mng70

Question

Hi everyone. I was hoping I could get some advice on an issue I'm experiencing on recently installed Nanao MS9 monitor / chassis in my Egret II. I appear to have some geometry issues. I have been playing around with the chassis pots (using Emphatic's useful guide) and the pots on the remote board but I always appear to have a wave as seen on the screenshots below.

I hope I've managed to share the images below correctly. Please inform me if you cannot view them.

 

https://photos.app.goo.gl/QVyk9XK7RjDWJPDq5

 

https://photos.app.goo.gl/A6MFxM6bWSYd4bWu5

Ignore the green vertical line.

 

https://photos.app.goo.gl/A6MFxM6bWSYd4bWu5

 

https://photos.app.goo.gl/pShdRaRd1wCQrPC4A

 

I do have access to another shared chassis (the same Nanao chassis as the one that is currently connected except it has the manual 15KHz / 24KHz adjustment). Could it be a chassis issue and is it worth swapping out or do you think it is a tube issue?

 

Although I am quite new to monitor diagnosis any help would be gratefully received.

 

Many thanks

 

mng70

 

- - - Updated - - -

 

A couple of videos of the display can be viewed here

Link to comment
Share on other sites

1 answer to this question

Recommended Posts

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...