Jump to content
Due to a large amount of spamers, accounts will now have to be approved by the Admins so please be patient. ×
  • 0
IGNORED

Someone help testing NeoGeo MVS 1A board


modology

Question

I just bought an NeoGeo MVS 1A board with that comes with 38in1 multicart.

Unfortunately i no longer have the dedicated cabinet to test out the board

 

I was trying to hook up the board via my Has Supergun hooked up directly Sony BVM via RGB BNC cables.

There were nothing appear on screen and it shows no sync.

The board looks like it powers up as the red led lighted up (the led light near the DIP SWITCH on the side)

 

I just don't know if the board is actually still working or dead unless i can find a dedicated jamma cab to test the board on

 

Can someone who lives in south easter suburbs of melbourne would lend a hand to help me testing out the board?

 

Thanks

Link to comment
Share on other sites

3 answers to this question

Recommended Posts

  • 0

If the cart is no good itll show a crosshatch screen, start the machine with no cart and get it working from there.

 

The other thing is the MVS edge connector is not the same as JAMMA, so if there is a switch then it needs to be on the correct setting for your supergun.

 

Im not sure if the 1A has the JAMMA MVS switch or not, id have to see the board.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...