Due to a large amount of spamers, accounts will now have to be approved by the Admins so please be patient.
×
- 0
IGNORED
CPS2 Voltage/Jamma Harness
-
Recently Browsing 0 members
- No registered users viewing this page.
Question
cps2luva
Hi all, at the moment i'm trying to get picture and sound out of my cps2 a+b setup. I'm using an arcade psu and one of those 'cheapo' harnesses off ebay, originally measured at around 4.10 for 5v at the edge connector. Since then i've bumped my psu dial until I reached 4.65 on the edge connector however I don't want to increase it anymore as my 12v is reading also around 12.65. I think this could be an issue with the jamma harness? Does anyone have any suggestions on how I can address the 5v on the edge connector being so low whilst not increasing my 12v? Possibly a new harness/adding some more wire? Also how high with the 12v can I go until I start producing problems?
Thanks,
cps2luva
Link to comment
Share on other sites
6 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now