Due to a large amount of spamers, accounts will now have to be approved by the Admins so please be patient.
×
- 0
IGNORED
Flipper Alignment/Fall Back Position Problem - Gottelib System 3
-
Recently Browsing 0 members
- No registered users viewing this page.
Question
Muzac
Hi good people,
I have a nagging quirk with my Cactus Jacks regarding the flipper positioning and I'm hoping someone can help.
I have rebuilt the flippers, painstakingly aligned then and they are working beautifully.
However, when you activate the right side flipper and let it go again it will fall back into a position that is a few millimetres higher than it should be. By activating the left flipper a few times, the right will drop back in increments to it's correct position.
The right side will also drop incrementally if other solenoids are firing, especially when the drop targets reset.
Any ideas and/or assistance would be greatly appreciated.
Cheers!
Sent from my iPad using Aussie Arcade
Link to comment
Share on other sites
10 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now