Jump to content
Due to a large amount of spamers, accounts will now have to be approved by the Admins so please be patient. ×
IGNORED

Addams family bookcase installation


Recommended Posts

Hi, I have recently installed a new bookcase plastic for the Addams pinball. I have already figured out how to raise and lower the bookcase, but I can't figure out how to make it sit perfectly balanced and flush with the playfield. Any suggestions?
Link to comment
Share on other sites

From memory there are 4 fixing points. Use packers under the leg. Perhaps a thin metal washer or even use an ice cream container and cut a round of plastic.

Really anything that provides a firm spacer. Trial by error really until it levels on all sides of the playfield.

Hope that helps. [emoji106]

 

 

Sent from my iPhone using Tapatalk

Link to comment
Share on other sites

So that means the opposite fixing point it too high. It needs a 'negative' packing.

So pack the two or even the other four. That will give the net result.

It's a time consuming fiddle, and some trial by error, but it is possible to level it using the 5 fixing points.

Good luck [emoji106]

 

 

Sent from my iPhone using Tapatalk

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...