Jump to content
Due to a large amount of spamers, accounts will now have to be approved by the Admins so please be patient. ×

Recommended Posts

I've got a couple of questions about this board after looking through the conversion kit instructions.

Do I need a filter board to operate the board?

And what's the story with pin 9 on the H connector? The instructions label it as 12v but both the original pinout sheet I got with the board and the online pinout show it as 13v can someone please confirm the correct voltage? I'm guessing the book is correct.

Cheers Trev d6a8b99fbe6a71898087e3d24eb402ce.jpg9b1c792cc292f55c8df915599b2738f9.jpg

 

Sent from my SM-G930F using Tapatalk

Link to comment
Share on other sites

13v is for the coin mech lickout supply.

Don't worry about if you don't have lockout coils.

Hooking 12v up to it won't hurt anything.

I think the 13v was an isolated supply from the audio to reduce 'noise' caused by the couls.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...