Jump to content
Due to a large amount of spamers, accounts will now have to be approved by the Admins so please be patient. ×
IGNORED

CPO - direct stick or is a aluminium panel required?


Recommended Posts

Just after some advice on whether mounting joystick to the plastic moulding without an aluminium panel or similar will be ok or is it likely to stress the plastic. Was trying to gauge if an overlay can direct stick to plastic or if the backing is needed to stop screws pulling through plastic. Thanks.

 

http://uploads.tapatalk-cdn.com/20160720/8739b65d6e6a19e9563f7c26210cddc7.jpg

Link to comment
Share on other sites

Yeah I thought someone was going to say that :) - thank you.

 

Are there any alternate materials you suggest that you can work yourself or is it best to just get Alu lasercut?

Link to comment
Share on other sites

Do you already have a stick? A lot of them will come with a mounting plate of mild steel or similar. The JLFs certainly do, if you get the right variant. And there are universal mounting plates available too, though where you'd get one for reasonable money I'm not sure, and you might need to cut it down to fit that CP.

 

http://www.paradisearcadeshop.com/637-mounting-plates but shipping is a total biatch.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...