Due to a large amount of spamers, accounts will now have to be approved by the Admins so please be patient.
×
- 0
IGNORED
One button registering as a press when released
-
Recently Browsing 0 members
- No registered users viewing this page.
Question
2playornot
Hi AAF,
I have a challenger cabinet which I've connected to a JPAC.
I have an issue with button 6 (Heavy kick) on the player 2 side.
In the image below, I've wired a daisy chained ground from button 4 (Light kick) closest to the joystick, to the button 6 (Heavy kick) then to the ground on the JPAC for player 2 as well as wiring the 4,5 and 6 buttons. The ground on button 4 is not connected to anything. Buttons 4 and 5 work when pressed, however button 6 only activates after the button is released after each press. As a test, I replaced the microswitch for button 6 (white switch in the picture) but this did not change anything.
Buttons 4, 5 and 6 on player 1 have been wired in the same way and work when pressed immediately. I'm unsure why only button 6 on player two side is activating after being released.
Could someone please assist? Please advise if you need any other information.
Thanks,
2playornot
Link to comment
Share on other sites
6 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now