Jump to content
Due to a large amount of spamers, accounts will now have to be approved by the Admins so please be patient. ×
IGNORED

Creation Cut CR Series vinyl plotter (faulty) and rolls of vinyl


Recommended Posts

Hi All,

 

Have a plotter and some rolls of vinyl to give away. Had grand plans to make my own cabinet stencils but never got there. Was working well but didn't use it for months and when i went to use it again the head would move slightly but nothing else would happen. Could be as simple as drivers or an update to my system stopping it communicating properly or could be a faulty pcb in the plotter. Needs to run via USB serial port drivers on a 32bit system. I'm too time poor these days to be bothered trying to get it working. Whoever takes it will also get the rolls of vinyl.

 

https://www.dropbox.com/sh/dfjaiqali0enruc/AABczhZ2nPadYKlZZGjX8cFZa?dl=0

 

Pickup only due to size from Upper Mt Gravatt

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...