Jump to content
Due to a large amount of spamers, accounts will now have to be approved by the Admins so please be patient. ×
  • 0
IGNORED

Help with calibrating CRT


Mickey Juice

Question

Hey dudes,

 

I just got a chassis repaired and I was just trying to calibrate it for a nice picture.

I had to turn the screen control up, as the screen was too dark and I was maxing out the brightness and RGB pots on the neck PCB... which was giving me bad bleeding.

 

Just a question, for getting a good colour calibration, should I use the pots on the neck PCB or the 3 'gain' pots on the chassis board?

 

And i'm assuming the colour bars are the best thing to use when calibrating? .. and they should trail off too darkness at the bottom of the screen?

 

Any other tips would be handy!

 

Thanks!

Link to comment
Share on other sites

1 answer to this question

Recommended Posts

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...