Nakaleen Posted August 10, 2011 Share Posted August 10, 2011 (edited) I am at the software stage of my mame cab. While I am working on that I am trying to get my Coin Slots to work. I got 2 CM01 from OzStick but they don't work. I put in a 20c and it just falls out the side. I tried to adjust the bar lower the the screws were locked tight (looks like some bluish glew) and now I have striped the screws so I am now stuck at its current settings. So I am wondering, the site said they were set for 20c, do I have to mount the coin slot on a slight angle as the insert slot is on a angle? I hate to have to get new ones. Sorry for the poor photo, using a camera phone in a not well lit room. Where I striped the screws (making them useless) Edited August 10, 2011 by Nakaleen added photos Link to comment Share on other sites More sharing options...
Nakaleen Posted August 10, 2011 Author Share Posted August 10, 2011 Just wondering, is the CM02 easier to use (and adjust)? I am prepared to buy two (I hope they fit the holes in the font panel I have made for the CM01's). Link to comment Share on other sites More sharing options...
spondy Posted August 13, 2011 Share Posted August 13, 2011 Might try throwing an email to OzStick for instructions on adjusting them. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now