Jump to content
Due to a large amount of spamers, accounts will now have to be approved by the Admins so please be patient. ×
IGNORED

Twilight Zone


Recommended Posts

Hi

After a good run with my machines I now have a problem with my TWZ as when in game mode when the gumball is opened up the diverter will not move and allow the ball to go to the gumball but the switch act as if it has gone there. I have tested the diverter on test mode and it works so I think it could be a problem with either the ribon cable from the cpu board or the pins that run to the power board . I was wondering if anyone else has had this problem and give me some advice on where to work this problem out

Thanks Frank

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...