Jump to content
Due to a large amount of spamers, accounts will now have to be approved by the Admins so please be patient. ×
  • 0
IGNORED

Fluke Multimeter Calibration


pinnieroom

Question

Not sure if this is the right place for this, but here goes...

 

I have a Fluke 112 multimeter which had some battery damage. I was able to repair it with a couple of hacks and it seems to read the right values. But I don't have the right equipment to test it fully.

 

Is there anywhere I can take it to in Melbourne that will calibrate / test it for me?

Link to comment
Share on other sites

3 answers to this question

Recommended Posts

  • 0
just do similar tests with another meter see if its the same

 

Yep - have been doing this, but my power supplies don't go up very high. About 20-30 Vdc. I'll try chaining a few supplies together to get a bigger voltage and see how that goes.

 

Since it was a bit of a hack job (as is usually the case when I'm concerned :) ), I didn't want to waste too much more time/effort/cash on it.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...