guys, on my sttng machine thre are 2 bulbs which keep going out. i have replaced them and they work for awhile but then seem to stop working. after taking the lamp board out i can seethat the socket that these bulbs go into are loose. i push them back in a bit and replace the board and again they work for awhile before stopping.
it appears that they need to be resoldered to the board so that they are firmly attached to the board. i have never soldered in my life. does this seem like the general way to fix this problem. is this a common problem on machines .
Question
highlander2287
guys, on my sttng machine thre are 2 bulbs which keep going out. i have replaced them and they work for awhile but then seem to stop working. after taking the lamp board out i can seethat the socket that these bulbs go into are loose. i push them back in a bit and replace the board and again they work for awhile before stopping.
it appears that they need to be resoldered to the board so that they are firmly attached to the board. i have never soldered in my life. does this seem like the general way to fix this problem. is this a common problem on machines .
thanks brett
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now