Jump to content
Due to a large amount of spamers, accounts will now have to be approved by the Admins so please be patient. ×
IGNORED

Hankin Logo


Recommended Posts

I've traced out all the borders for the hankin cocktail cabinet here.

(reversed for vinyl application to the glass)

 

This one was a bit trickier but got there in the end.

 

Edit: file updated (Hankin logo made slightly smaller as per original artwork provided to Wob by Mooncresta)

Hankin_Borders_rev.pdf

Edited by Bump
Link to comment
Share on other sites

Yup

 

The outside glass was 804x602mm

The outer black edge came in around 3mm inside that, leaving the outer dimensions as 798x596mm.

 

The inside border around the monitor is 487x487mm (14mm thick) which leaves a clear area of 459x459mm.

Link to comment
Share on other sites

"Hankin_Borders_rev.pdf" file has been updated in previous post to the same scaled size as the updated scaled logo.

 

(The Hankin logos were made slightly smaller to conform to the exact sizing provided to Wob by Mooncresta)

Link to comment
Share on other sites

  • 3 years later...
  • 4 years later...

And my machine is still in a state of restoration [emoji849] I have all the parts, just need to put them all together. Life and other projects got in the way

 

Sent from my SM-G935F using Tapatalk

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...