Due to a large amount of spamers, accounts will now have to be approved by the Admins so please be patient.
×
- 0
IGNORED
Stellar Wars - Rom updates ???
-
Recently Browsing 0 members
- No registered users viewing this page.
Question
ToyTech
Hi All,
Just recently acquired an old Williams (1979) "Stellar Wars" machine - super WIDE pinball measuring approx 70cm wide glass top, nice BIG playfield....although some might think it's too slow...
Anyway, i was looking into rom updates, making sure my machine is running as best as it can, but i'm getting some mixed information.
According to most pin-rom sites, my machine should have a Williams Sys-4 MPU board in it, even the manual i have shows a Sys-4 inside.
However, my machine actually has a Sys-6 board in it. (not an 'A/B/C/D" revision etc).
So, can anyone shed any light on whether the roms i get off the net (which state they're for the Sys-4 board) will work on the Sys-6 board?
They both seem to use the same rom names (U14 game, and U17+20 flipper).
I'm no stanger to rom copy/burning etc (part of my job), so i'm sure to try a few things out and easily go back to safe mode with original roms again ;-)
Thanx in advance,
Marty (ToyTech).
Link to comment
Share on other sites
17 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now