Due to a large amount of spamers, accounts will now have to be approved by the Admins so please be patient.
×
- 0
IGNORED
Bally Supersonic Drop Target Assembly Issue
-
Recently Browsing 0 members
- No registered users viewing this page.
Question
LAP
I recently bought Supersonic machine and the drop targets were old worn and had a tendency so stick so I thought I would replace the worn drop targets and while I was at it service the whole assemble and give it a once over.
Assembly Diagram and Before Picture:
After replacements drop targets installed and assembly serviced and cleaned..... but after each reset 2 or 3 of the 5 Drop Targets are pushed up too high and then are stuck up and don't drop when hit
Case where Drop Target does work ==> Where Reset Link arm is in the groove on back End Plate
Case where Drop Target does not works ==> Where Reset Link arm is outside the groove on back End Plate
I suspect it is a matter of the Reset Bar pushing the Reset Links too high so the Reset Links slip out of the groove on the back End Plate and I was struggling to find where this can be adjusted...
Any help or suggestions welcome....
Jason
Link to comment
Share on other sites
5 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now