Thanks Thanks:  0
Likes Likes:  0
Results 1 to 1 of 1

Thread: Point Blank 2 wiring confusion

  1. #1
    Join Date
    Dec 2012
    State
    Frankston, Victoria
    Posts
    351
    Mentioned
    18 Post(s)
    Quoted
    71 Post(s)

    Point Blank 2 wiring confusion

    Hi all,
    I just received guns, pcbs, wiring and IO board from @bwodie (10 thumbs up buddy)

    I have pb1 and pb2 pcbs and unfortunately the 15 pin molex that goes to J2 on IO board for pb2 is different to the other pb1 15 pin molex, and I am a bit confused/scared to plug the pb2 molex into the io board because pin 3 from pb2 is an earth (Right Plug in photo), whereas the pb1 pin 3 is a 12v!!!! (Left Plug) All schematics I have seen say that the left plug is correct across pb 1, 2, 3

    From everything I have read over the internet these 2 pcbs and IO are supposedly the same wire for wire identical, but mine are not.
    Also, it looks like I cannot use the pb1 molex loom because it is different again from the pb2 loom

    Pictures added to hopefully help clarify.

    Any help would be greatly appreciated
    Attached Images Attached Images

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Point blank wiring pcb
    By gt-ray in forum Arcade Technical and Repair Questions
    Replies: 2
    Last Post: 26th May 2018, 12:27 AM
  2. wiring a cab for point blank
    By wallaroo1979 in forum Arcade Technical and Repair Questions
    Replies: 11
    Last Post: 15th October 2014, 12:32 AM
  3. point blank wiring
    By wallaroo1979 in forum Arcade Technical and Repair Questions
    Replies: 5
    Last Post: 28th October 2011, 10:27 PM
  4. Point Blank Wiring Help
    By IAMWZL in forum Arcade Technical and Repair Questions
    Replies: 5
    Last Post: 5th March 2010, 06:11 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •