FIXED: WOZ slow ball gets stuck.

Are the pics after yiu adjust the height and switch arm? If so, adjust it a lot more!

Also, could put spacers under the switch mount to raise it off the ramp.

Or hit the shot harder ha ha

Sent from my ALP-L29 using Tapatalk

Are the pics after yiu adjust the height and switch arm? If so, adjust it a lot more!

 

Also, could put spacers under the switch mount to raise it off the ramp.

 

Or hit the shot harder ha ha

 

Sent from my ALP-L29 using Tapatalk

The pixs are the original fault, I've raised the switch arm as high as I can any higher & it wont register the ball passing. The problem I see is that position on the ramp is pretty flat (east-west wise) even though the machine is as steep as it goes. I'm thinking of moving the switch further back on the slope might help.

- - - Updated - - -

Ask for your IJ back

:lol No Pete I like WOZ all the little problems are fixed this is the only one left. WOZ is a keeper IMO. :)

Is that the right switch?

Yes just before the intersection. Anyway I've done some thinking outside the square & seemed to have found a fix (So Far).

What Ive come up with is to leave the switch alone & raise one side of the ramp so the ball will roll forward avoiding the flat spot. I used a couple of post rubbers under the supporting post to raise the angle. So far it's worked.