So - ordered some very uncommomn SRAM chips and found that they are the normal width chips (15.2mm leg width) as opposed to the narrow width chips (7.6mm) that the board had originally.
Given that I am unlikely to find the narrow versions of these chips, I am resigned to making adapters. So I need to go from a 28PIN DIP socket with 15.2mm leg spacing down to a 28PIN DIP male with 7.6mm width. (2.54mm pitch on both ends).
I am thinking that I will just get a normal 28 pin dip socket, some header terminal strips and a vero type PCB board to make adapters.
Is there a better way to do this, or low cost, pre-built alternatives as I need to do this for a few chips?
Question
Berty
So - ordered some very uncommomn SRAM chips and found that they are the normal width chips (15.2mm leg width) as opposed to the narrow width chips (7.6mm) that the board had originally.
Given that I am unlikely to find the narrow versions of these chips, I am resigned to making adapters. So I need to go from a 28PIN DIP socket with 15.2mm leg spacing down to a 28PIN DIP male with 7.6mm width. (2.54mm pitch on both ends).
I am thinking that I will just get a normal 28 pin dip socket, some header terminal strips and a vero type PCB board to make adapters.
Is there a better way to do this, or low cost, pre-built alternatives as I need to do this for a few chips?
Link to comment
Share on other sites
12 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now