No didn't Vector it. This can be done with photoshop but it isn't perfect on a small jpeg. I will Vector one as well and see what is better.
I got your PM so will email it. I will remove the URL also.
Can't do A3 without changing the proportions (stretching one demension)
It is now A3 width and I increased the DPI from 100 to 300 so should print better.
Is that what you wanted?
That attached file is downscaled for AA so PM me your email address and I will send you the full file 3mb. Also if you have the original jpeg it may be better than the one I pulled off AA.
Thanks Vett, I thought LED2&3 were left out on some boards.
Thanks Homepin, The actual voltages are as follows:
TP1 14 volts (should be 12V)
TP2 4.85 volts (Normally 5v)
TP3 12 volts (normally 12v)
TP6 72 volts (normally between 50-70v)
TP7 21.4 Volts (normally 20v)
TP8 constantly fluctuates - range between 13.5 volts and 17 volts (should be 18v but is only the lamp matrix)
Any thoughts appreciated.
Still trying to work out ongoing random errors and have a question about the Power Driver board LED's. The TOM manual states that LED 2 and LED 3 on the power driver board are not used however a number of internet resources suggest on WPC-S boards LED2 should be on and LED3 should be off to signify correct voltage. In my case both LED's are on suggesting low voltage. Any thoughts on whether these LED's are in fact used (ignoring the manual) and perhaps if anyone with a TOM can tell me what is the state of LED's 2 & 3 when their machine is powered on.
Thanks