Jump to content
Due to a large amount of spamers, accounts will now have to be approved by the Admins so please be patient. ×
  • 0
IGNORED

Coil help please. LW3


Bishop

Question

Hello all,

 

So purchased a new coil, installed and tested. Was a no go. So now I swapped the coils over (slings) to make sure it was the coil. (Checked coils with a multimeter got a reading on the old but not the new.) turned in machine and went pop with that beautiful scent and a puff of smoke. All fuses are all still intact. Where can I start looking to sort this out? Thanks.

Link to comment
Share on other sites

4 answers to this question

Recommended Posts

  • 0
  • Administrators

Transistors for the Slings and Pop bumpers on DE's are on the CPU board in the top right. If its popped it should be pretty easy to find the bad one if not use a multimeter on diode test. (I don't have the manual on hand)

Chances are you'll need to change the pre driver as well.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...