Jump to content
Due to a large amount of spamers, accounts will now have to be approved by the Admins so please be patient. ×

Roscoe

Aussie Arcade Member
  • Posts

    53
  • Joined

  • Last visited

Personal Information

  • State
    Wellington

Roscoe's Achievements

Contributor

Contributor (5/17)

  • First Post
  • Collaborator
  • Conversation Starter
  • Week One Done
  • One Month Later

Recent Badges

12

Reputation

  1. At least you don't need a Swords of Fury, you flogged me on that!
  2. Please count me in Yee for both Wellington and Auckland. Can't wait.
  3. That's not funny Quade Cooper, but really it was a pleasure to meet you too. Hope you make the trip next year.
  4. Really sorry to hear of your loss Troy. Take care.
  5. OK emailed you a cleaned up final version A3 @ 300DPI. hope that works for you.
  6. No didn't Vector it. This can be done with photoshop but it isn't perfect on a small jpeg. I will Vector one as well and see what is better. I got your PM so will email it. I will remove the URL also.
  7. Can't do A3 without changing the proportions (stretching one demension) It is now A3 width and I increased the DPI from 100 to 300 so should print better. Is that what you wanted? That attached file is downscaled for AA so PM me your email address and I will send you the full file 3mb. Also if you have the original jpeg it may be better than the one I pulled off AA.
  8. Hi guys, Thank you so much for this whole thread. Absolutely loved reading it. Cheers.
  9. Thanks Darksoul, I did reseat all the connectors and ribbons the other day but will give it another go now and see how that goes. Thanks
  10. Thanks Vett, I thought LED2&3 were left out on some boards. Thanks Homepin, The actual voltages are as follows: TP1 14 volts (should be 12V) TP2 4.85 volts (Normally 5v) TP3 12 volts (normally 12v) TP6 72 volts (normally between 50-70v) TP7 21.4 Volts (normally 20v) TP8 constantly fluctuates - range between 13.5 volts and 17 volts (should be 18v but is only the lamp matrix) Any thoughts appreciated.
  11. Still trying to work out ongoing random errors and have a question about the Power Driver board LED's. The TOM manual states that LED 2 and LED 3 on the power driver board are not used however a number of internet resources suggest on WPC-S boards LED2 should be on and LED3 should be off to signify correct voltage. In my case both LED's are on suggesting low voltage. Any thoughts on whether these LED's are in fact used (ignoring the manual) and perhaps if anyone with a TOM can tell me what is the state of LED's 2 & 3 when their machine is powered on. Thanks
  12. Yeah it was a blast and I'm looking forward to it already. Very small contribution from me but you are more than welcome.
×
×
  • Create New...