Jump to content
Due to a large amount of spamers, accounts will now have to be approved by the Admins so please be patient. ×

weedy

Aussie Arcade Member
  • Posts

    194
  • Joined

  • Last visited

Personal Information

  • State
    QLD

weedy's Achievements

Collaborator

Collaborator (7/17)

  • First Post
  • Collaborator
  • Conversation Starter
  • Reacting Well
  • Week One Done

Recent Badges

392

Reputation

  1. Twisted pins did. I have one of those as well, it is shit.
  2. Is there a way to test if each pin (for example J121) is getting power? I think the problem is the female connector because the connector that drives the backbox and playfield flashers works fine in both J120 and J121 but the same cannot be said for the GI strings.
  3. ah, good point. I hadn't thought of that. I do have a burnt connector at pin 11 on what was in J120 but is in J121 in vett's machine with the placement of wires also different. Time to take the board out and check the traces for any repairs.
  4. No problem. Can post it this week. PM me your details.
  5. White water flat decal topper. This is not an original foil topper, but rather the step above no topper at all. It is a flat decal on a new white plastic support. $20 ono. Pick up from Red Hill, Brisbane.
  6. Trying to chase down a GI problem with my WH20 whereby the GI doesn’t work during a game. It does work in test mode but not as it should. For example, in test mode when it is running the upper playfield GI, the GI under the slings is lit and when the lower playfield GI test is running, no GI is lit. Looking at the manual, the GI runs in to J120 and J121 (backglass). The pins on the connectors in my backbox though aren’t what is specified in the manual so I’m thinking the person I bought it off has reworked it wrong at some stage. Can someone with a WH20 please post a photo of their J120 and J121 backbox pinout so I can verify? PS. I have noticed that several of the fuses are the wrong type (3A instead of 5A) so an easy fix there. Thanks!
  7. Looking for something stronger for my TZ but that can easily be removed
  8. Looking for one (or more) Cliffy universal switch slot protector. Local parts stores are all out of stock.
  9. I'm interested in the JD. Just waiting on some pics from Rod via the handyman.
  10. Has some scratches and a few very minor chips on one short edge No cracks or chipped corners. Totally free to good home or bad home.
  11. Be more than happy to help out anyway I can after all the help you’ve given me mate! soldered a new Tip36c on, replaced a blown fuse (looked ok but was dead on the test) and now all magnets are working well. Even realised the two main pf magnets weren’t working due to blown fuse which would have been caused by the blown transistor. Now to adjust the pole height on the magnet bracket to stop balls getting stuck in the depression.
×
×
  • Create New...