Jump to content
Due to a large amount of spamers, accounts will now have to be approved by the Admins so please be patient. ×
  • 0
IGNORED

IJ PoA help??


ROLLERBALL

Question

Ok guys...just got a IJ....but the PoA has issues...

First of all it has a globe out and one switch is not working..Ok thats no big deal to fix BUT how do you get to the underside of the PoA???Can I lift it out or up somehow...Im sure someone on here will know how to do it...any tips??

 

Also In some of the modes with the PoA after Ive had a run down the PoA with the ball then the DMD says to go for the PoA and get the rest of the lights...but while the mode is still running I will get the ball back up to the PoA but it goes straight past it and down the side???Isnt the post suppose to pop up???It pops up for the start of the PoA mode then thats all...

 

Thanks for any help in advance...cheers

 

paul

Link to comment
Share on other sites

21 answers to this question

Recommended Posts

  • 0

PoA: Path of Adventure.....

 

From memory there is an Allen Key required to loosen a screwat the very back of the PoA and I think you need you need to remove the rail behind it as well. Should slide out from there....An easy job when I did it a few months ago....

 

These may be better instructions than my last attempt!!!!:rolleyes

 

1. Disconnect the PoA cables from the underside of playfield.

2. Remove the Bridge above PoA ? 3 screws, 2 on the top, 1 below.

3. Remove lower left lamp.

4. Remove the plate and the slide ? 2 screws in each and remove both of these.

5. Loosen the set screw from the motor shaft at the rear of PoA.

6. Remove the 2 screws holding the PoA. Slide the PoA straight forward and lift off.

Link to comment
Share on other sites

  • 0
PoA: Path of Adventure.....

 

From memory there is an Allen Key required to loosen a screwat the very back of the PoA and I think you need you need to remove the rail behind it as well. Should slide out from there....An easy job when I did it a few months ago....

 

These may be better instructions than my last attempt!!!!:rolleyes

 

1. Disconnect the PoA cables from the underside of playfield.

2. Remove the Bridge above PoA – 3 screws, 2 on the top, 1 below.

3. Remove lower left lamp.

4. Remove the plate and the slide – 2 screws in each and remove both of these.

5. Loosen the set screw from the motor shaft at the rear of PoA.

6. Remove the 2 screws holding the PoA. Slide the PoA straight forward and lift off.

Also in addition to the above make sure you use a good quality allen key of the correct size as the motorshaft grubscrew usually has Loctite on it and is blood tight and don't let the PoA just hang by the motor shaft after removing the front support or you will damage the motor.
Link to comment
Share on other sites

  • 0

..

 

All done..thanks for the tips...

PoA was not working properly as you couldnt get the ball for one side to the other without going into the pit...was ok one way but not the other....so squared it all up...replaced the blown globe...cleaned the filth that was under the PoA and now its as good as gold..

Link to comment
Share on other sites

  • 0

..

 

TZ is rubbish...the IJ from what Ive played so far is way more fun...

Put it this way my wife said I could keep the TZ and the indy in my collection if i sold my Getaway and stingray...so played a few game just to see...and yes...the Getaway kicked the TZ ass as far as fun and gameplay...But look thats just me..Im sure there are guys that hate the getaway and love the TZ...TZ is a great game...just not for me thats all...

Link to comment
Share on other sites

  • 0

UPDATE

 

UPDATE...IJ sucks the big one....have to get rid of it asap...

 

The wife (Louise) loves it...she just SMOKED the highest score on it the first time she played it...even asked me on her 4th ball if the machine only had 2 flipper on it...DOH...

 

lol...not happy..lol

Link to comment
Share on other sites

  • 0
Guest Burra749
UPDATE...IJ sucks the big one....have to get rid of it asap...

 

The wife (Louise) loves it...she just SMOKED the highest score on it the first time she played it...even asked me on her 4th ball if the machine only had 2 flipper on it...DOH...

 

lol...not happy..lol

 

:lol

Now you know why I sold it.

This was my wifes fav machine, I couldnt even come close to her scores.

She said to pass on this message

"You go Girl"

Link to comment
Share on other sites

  • 0

...

 

Yeah thanks for that Burra...rub it in...you could have told me about that before i got it...lol...

Oh well looks like Ive got a challenge ahead of me now....I should have told her that the 3rd flipper is hidden until you get a special mode up..lol..

Link to comment
Share on other sites

  • 0
My missus beat me on fishtales one night by hitting the credit button after I racked up a cracker score before I could enter it.:x _ foul play I called. Love Ij but I think it may be time to move onto other projects so thinking about selling it.
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...