Jump to content
Due to a large amount of spamers, accounts will now have to be approved by the Admins so please be patient. ×
  • 0
IGNORED

Power Supply Question


MaddogDU

Question

Working on this conversion. It has the old linear power supply with a transformer. It looks like the previous owner added one of the Happ comtrol switching power supplies that I'd like to take out and use in another machine.

 

I ordered a 1069 in 1 board and it came with an ATX power supply and I am having a hard time figuring out how to wire it up (newbie). Is it as simple as plugging up the AC power chord to the ATX and plugging the 20 pin connector from the ATX to the mother board? Can I then just remove all of the linear stuff, the transformer and the old Happ power supply? I want to know if I can rip out everything in picture 1 and just plug in picture 2.

 

Thanks-

Maddog

EverythingGame pictures 053.jpg

EverythingGame pictures 050.jpg

Link to comment
Share on other sites

6 answers to this question

Recommended Posts

  • 0
it wil power the marquee but you wil need to rewire the jamma harness with a 12v line from the atx power supply. Its a whole lot easier using 2 power supplys but it can be done with just the one if you want to do the work.
Link to comment
Share on other sites

  • 0
the 20 pin plugs into the mother pcb (game board) you will still need the old 12v & 5v power supply did you get the wiring diagram if not i can send it too you with button wiring its not that hard also make sure you check the voltage and set it on the correct voltage on computer power supply?????????????????
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...