VPGL10 Game 3 Indiana Jones The Pinball Adventure - Williams (finished)

[Dedrok]

See. It does fuk up and freeze.
Not just me.


Sent from my iPhone using Tapatalk

[JustAnotherRat]

See. It does fuk up and freeze.
Not just me.


Sent from my iPhone using Tapatalk

...and it sucks

[Jed]

See. It does fuk up and freeze.
Not just me.


Sent from my iPhone using Tapatalk

Nah, it's just you and JAR.

And JAR gives you your games, so it's really just JAR

I've never had a freeze on Indy, but I'm using the 1.1 version as the 1.2 version game me script errors.

[Dedrok]

Nah, it's just you and JAR.

And JAR gives you your games, so it's really just JAR

I've never had a freeze on Indy, but I'm using the 1.1 version as the 1.2 version game me script errors.

Happened on vp8 as well years ago at 9.7Bil.


Sent from my iPhone using Tapatalk

[skids]

Game now closed, well done Wob.

[JustAnotherRat]

Nah, it's just you and JAR.

And JAR gives you your games, so it's really just JAR [emoji38]

I've never had a freeze on Indy, but I'm using the 1.1 version as the 1.2 version game me script errors.

The ones I gave Dedrok were from Wob's cab.

[JustAnotherRat]

Super close this one

[Jed]

this would have to be one of the highest performing/closest games ever, well played everyone.

I went for a last ditch bash last night but got some Ipac problems everything is fine until I plunge the ball.... flippers work, credits, can start a game, but plunge a ball and the ipac goes dead - light goes off on the board and nothing responds. going to have to dive in and do some rewiring / fiddling with switches, my plunger is dodgy as hell though and pulls a microswitch lever based on a loop of cable ties and fishing line

[JustAnotherRat]

this would have to be one of the highest performing/closest games ever, well played everyone.

I went for a last ditch bash last night but got some Ipac problems everything is fine until I plunge the ball.... flippers work, credits, can start a game, but plunge a ball and the ipac goes dead - light goes off on the board and nothing responds. going to have to dive in and do some rewiring / fiddling with switches, my plunger is dodgy as hell though and pulls a microswitch lever based on a loop of cable ties and fishing line

It's not tilting is it? I don't have an explanation but sounds like it is tilting.

[Dedrok]

[Jed]

It's not tilting is it? I don't have an explanation but sounds like it is tilting.

No, as the whole Ipac goes dead - not the game. I found out what it was though, totally my fault some bad positioning of a coin door microswitch (plunger button) the backside was pushing up against the lockdown bar lever inside the cab. Bend the pin over and then it bridged onto another terminal. That explains why it went dead whenever I used the hardware plunger or the plunger button as they were wired into the same ipac port.

Gives me an excuse I guess to tidy up the wiring and do a proper job once I can get a new one. I'm a bit of an out of sight out of mind type guy so it's a bit of a mess in there...

Nice games room @Dedrok where is that ?

[Dedrok]