Announcement

Collapse
No announcement yet.

Help - Wiring NRI Coin Mechs to Sunshine Credit board after Card system was used

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Help - Wiring NRI Coin Mechs to Sunshine Credit board after Card system was used

    Hi guys
    I am doing a Lazer-Tron "Chip Away Game" upright conversion and want to test these coin mechs, just saw the Help section of the forum and need some help to get my coin mechs working.
    Here the front and back of my cab:
    Click image for larger version

Name:	ChipAway.jpg
Views:	3
Size:	196.3 KB
ID:	1865886Click image for larger version

Name:	ChipAway-Inside.jpg
Views:	2
Size:	166.0 KB
ID:	1865887

    The problem is that my machine was modded to use a card reader system, which was removed prior to me buying it.
    So I dont know what the correct wiring should be and didn't want to just plug it in in case I fried something.
    Click image for larger version

Name:	Coinmech-chip.jpg
Views:	2
Size:	132.0 KB
ID:	1865888

    The below image is of the green finger connector that I assume plugs into the video credit board.
    Click image for larger version

Name:	CreditBoard-AndFinger.jpg
Views:	2
Size:	149.4 KB
ID:	1865889

    Close up of Sunrise Credit Board
    Click image for larger version

Name:	Sunrise-Credit-Board.jpg
Views:	2
Size:	150.9 KB
ID:	1865890

    The finger connector's wires hook into cabinet wiring with the "black and orange" wire going to the below LAI controller interface Board which then connects to the custom Lazer-tron ISA PCB in the PC via the cabinet wiring.
    That ribbon cable on the LAI cable goes nowhere just dangles.
    Click image for larger version

Name:	LAI-IsolatedControllerInt.jpg
Views:	2
Size:	136.6 KB
ID:	1865891Click image for larger version

Name:	LAI-Isolated-Int-Controller-Zoom.jpg
Views:	2
Size:	165.0 KB
ID:	1865892

    Can anyone tell me what the LAI controller interface board does and if I would need to change anything wiring wise, in particular that transistor thing in the wiring connector on the LAI board?
    If its too difficult to hook up as is, I will bypass the LAI board and I think I can hook up that Sunrise credit board to an Ipac and mame?

    Thanks guys, I hope that makes sense.
    Last edited by Fizgig; 10th January 2012, 06:29 PM.

  • #2
    Oh and FYI my project thread is at:
    http://www.aussiearcade.com/showthre...ght-Conversion

    Thanks again guys

    Comment


    • #3
      I just made up a tester over the weekend to test NRI mechs, I cant remember exactly the pinout of the board but in your picture of the board
      http://www.aussiearcade.com/attachme...167029&thumb=1


      The way you are holding it in the picture is how it goes on with the 12v at the bottom of the picture

      Comment


      • #4
        :nevermind. iPhone created a post by accident

        Comment

        Users Viewing Topic: 0 members and 1 (guests)
        Working...
        X