Jump to content
Due to a large amount of spamers, accounts will now have to be approved by the Admins so please be patient. ×
IGNORED

i-pac2 dimensions help please


Recommended Posts

Just measured mine, I have the PS2 version (not USB)...

 

53 x 98 x 16

 

You'll probaby want more space than 53 wide as the wires come out sideways.

 

Edit: and you'll want a few cms longer too for the PS2 cables! ;)

Link to comment
Share on other sites

i-pac2

 

Thanks MrQuan for the measure...that should just fit where i want it to.The ps2 size WAS the one i was after

Strange that the Ultimarc site hasn't even got the dimensions of this thing up...unless i didn't notice it .

And thanks to the others for the "INPUTS"

Link to comment
Share on other sites

Just measured mine, I have the PS2 version (not USB)...

 

53 x 98 x 16

 

You'll probaby want more space than 53 wide as the wires come out sideways.

 

Edit: and you'll want a few cms longer too for the PS2 cables! ;)

 

Hmmmmm

 

the USB and the PS2 ones are the same thing

 

just the cable is a PS2toPS2 or a PS2to USB

 

but remember to add 1 - 2 cm to the width for your wires to stick out and if you put it on PCB feet

Link to comment
Share on other sites

sorry ...but may be a dumb ?? but what are "PCB FEET" ????

this MAME machine building is not as easy as it sounds.. i cut & assembled the entire cabinet in about 4.5 hours ...BUT its taken me 4 weeks to decide the CP lay out ( & still not sure if im happy with it ) & then there is still colour selection of trivial shite ...like buttons & joy stick knobs to think about :unsure:unsure ...im sure lots of you have been there & done that

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...