PDA

View Full Version : Restoration tip needed



adp81
24th January 2014, 12:34 PM
Looking for some direction to repair this broken section above the coin op

thanks59784

Savage
24th January 2014, 01:13 PM
What I would do.

Sand it all down (preferably with an orbital sander) otherwise by hand.

Go to super cheap or a Automotive paint supplier and by a fibre glass repair kit.
Roughen / sand the inside and apply the fibre glass strips and then the resin

Once hardened use auto filler (car bog) and apply on the outside.
Sand and re-apply filler if needed.
When cured, sand with 240 grit or lower to get most of it down flat, then sand with a finer grade like 400 dry.

Use Primer filler (not just primer) all over the outside.
Nice even coats, do about 3 or 4.

Allow a few days to properly dry.
(use black paint lightly over for a guide coat)

Then sand with wet and dry 400 grit sand paper, until black paint is gone.

re do the black guide paint
re-sand with 800 grit.

Then paint.

kosmokramer
24th January 2014, 03:36 PM
Hey mate. I'm sure there was some one on here that had a few nos ones. Try searching the forum , or maybe a member remembers

- - - Updated - - -

http://www.aussiearcade.com/showthread.php/62969-Anyone-have-crusin-USA-machine-parts?highlight=Dash




Gibo is your man

adp81
7th February 2014, 12:30 AM
Gibo, Can you help out here?