PDA

View Full Version : Ipac config



Potato King
11th September 2006, 03:10 PM
Once again its time for the potatoes piss lame noob question of the week.

Finally got around to replacing my dodgy coin door ground wire on the w/end & got that working however when assigning the player 2 coin switch button in the Ultimarc config program it registers a "P" for pause, Iíve triple checked all the wires & it is definitely connected to the 2coin input.

Iím just wondering whether Iíve confused the I-pac by making 2SW8 the pause button & now this has affected my 2coin input? Can someone with an Ipac test this by making 2sw1 pause & see if 2coin is affected?

Chocolate covered potatoes on offer again.

RetroGame
11th September 2006, 03:35 PM
You can you check your Ipacs programming to see if coin2 has been reassigned. In a dos window type "copy con null" <enter> then press CTRL, ALT & P then type "L" to list your current config. You can make changes to your config from here as well.