Jump to content
Due to a large amount of spamers, accounts will now have to be approved by the Admins so please be patient. ×
IGNORED

New Flame LEDs and Pop Bumper LED


thegrunta666

Recommended Posts

Hi fellow AA'ers

I have just got some LEDs in from Comet pinball in the USA. I have installed their "Flame" led in 2 of the pop bumpers . This has 4 leads on it that cycle to create the Flame effect. In the other Pop Bumper is red leds on top and like a GI white led on the other side to light the base of the pop bumper. All on a cutom fit circuit board.

Cant decide whether I like the flame LEDs or not? Whats your opinion?

[video=youtube_share;sLQ-KAeRCWY]

Link to comment
Share on other sites

I like the look but I think a better effect would be had by softening it a little with white. The red just seems to intense as it is. Maybe a white or yellow LED or two inside the bumper on all the time with the flickering LED would be a nicer outcome.

 

You could try putting a resistor in series with the flickering LED kit and that may slow down the flash rate and soften the red a little also.

 

Thanks for showing us a kit I for one didn't know existed by the way thegrunta666.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...