Due to a large amount of spamers, accounts will now have to be approved by the Admins so please be patient.
×
- 0
IGNORED
Assembling a WPC089 MPU board from scratch
-
Recently Browsing 0 members
- No registered users viewing this page.
Question
Sabot68
HI all,
I have set myself the task of building up a WPC089 MPU board, partly as a project and to have a spare MPU board for my Addams Family pin.
While I have a basic understanding of electronic components (eg I can tell a diode from a resistor etc) and I am reasonably handy with a soldering iron (surface mount stuff still scares the carp outta me) this is by far the biggest project I have taken on.
I received the bare board today and have assembled 95% of the components.
My first question is... there are a bunch of pin outs labelled 'W' 1 through 9, on my bill of components these are described as 0 ohm jumpers, can I use the discarded legs of resistors for this or should the jumper be insulated wire?
I suspect I will have may other questions as I go along so I ask for your help and patience....
Andrew
Link to comment
Share on other sites
46 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now